Mobile service
We come to you in Atwood
Every job happens at your home. We pull up, set up a work area next to the grill, and do the cleaning or repair on the spot. You do not haul anything anywhere.
This matters most for built-ins. A grill set into a stone or stucco island is not leaving the yard, and a lot of companies will not touch one. We work on them in place all the time.
We cover Atwood and the neighboring communities of Placentia, Old Towne Placentia, Yorba Linda and Anaheim Hills. Pro Grill started in Southern California in 2018, and our technicians have 50+ years of combined grill experience between them. We have 2,500+ five-star reviews (Google, Yelp and Facebook), and we have serviced over 25,000 grills. We are insured, and we show up with the tools and parts for the job.

Deep cleaning
Deep grill cleaning
A deep clean is a full teardown, not a wipe-down. Here is what we go through:
- Cooking grates, scrubbed and inspected for rust and cracks
- Burners, cleaned inside and out, with ports cleared
- Heat plates or flavorizer bars, scraped and checked for burn-through
- Briquette trays and briquettes
- The firebox, cleaned down to bare metal where we can reach it
- Drip tray and grease management, emptied and cleaned
- Igniter electrodes, cleaned and tested
- Hood and outside stainless, cleaned and polished
- Cleanup of our work area when we finish
Buildup is more than a looks problem. Old grease feeds flare-ups and can turn a small flame into a big one. Carbon over burner ports gives you uneven heat, with one side of the grate scorching and the other barely cooking. Moisture trapped under grease and ash speeds up rust, and burners that sit in that mess rot out sooner than they should.
A clean grill works better and is easier to keep up. We do not promise it will look or run like new, because age and wear are real. We do get it cooking evenly and safely again.

Start with the symptom
BBQ repair at your Atwood home
Most grill problems come down to a worn part, a blocked passage or a loose connection. We repair burners, valves, igniters, grates, briquettes, heat plates, knobs and regulators, usually in one visit. These are the problems we see most around Atwood.
Spiders in the venturi tubes
Spiders build nests in the tubes that feed gas to the burners. The nest blocks the flow and you get weak flames, flames outside the burner, or a grill that won't light. We clear the tubes, clean the burners and check for damage.
Flare-ups and grease fires
Grease collects on heat plates, in the firebox and in the drip tray until it catches. We remove the buildup, replace burned-out heat plates or trays, and fix the grease path so it drains where it should.
Hot spots and uneven heat
Dust, debris and carbon plug burner ports and starve parts of the burner. We clean or replace the burner and check that the flame is even from end to end.
Low flame, even on high
The regulator can stick in low-flow (bypass) mode, which cuts the gas to a trickle. We test pressure, reset or replace the regulator, and confirm the grill reaches full heat.
Igniter clicks but won't light
Usually the electrode is dirty or out of position, the wire has failed, or the module is dead. We test each piece and replace only what is bad.
Heat shields and briquette trays burned through
These parts take the heat and eventually give out. Once they are gone, flames lick the burners and the heat gets patchy. We fit replacements sized for your model.
Smells like gas
Shut the gas off at the tank or the line and do not light the grill until it has been checked. Leaks usually come from a loose fitting, a cracked hose or a worn valve, and we find the source and fix it.
Repair it right
We diagnose before we replace parts
The same symptom can come from different causes. A weak flame might be a spider nest, a bad regulator or a clogged burner. If we guessed and swapped parts, you would pay for the wrong ones, so we test first and tell you what we found.
To speed things up, take a photo of the model and serial number label on your grill and send it with your request. On a built-in it is often inside the door or under the hood. With that label we can arrive with the right parts.
Our trucks carry parts for most brands. Anything we do not have on hand is available at store.progrill.com, which also stocks parts for most built-in grills if you want to order them yourself.
Built-ins & outdoor kitchens
Built-in grills and outdoor kitchens
If a built-in grill loses a burner, a valve or an igniter, repair almost always makes more sense than replacement. Pulling out a built-in means cutting into countertops, redoing gas connections and sometimes rebuilding the island. A new burner costs far less than all that, and the grill around it is often still solid.
We also design, fabricate and repair outdoor kitchens: islands, cutouts, access doors, counters and the grill setup that goes in them. If your kitchen needs work, we can look at the whole thing instead of just the grill.
The same trucks handle smokers, griddles, pizza ovens, fireplaces and fire pits.
Inspections & maintenance
Inspections and regular maintenance
An inspection is a full check of the gas supply, burners and ignition, finished with a written report. It tells you what is fine, what is wearing and what needs attention soon. That helps if you are about to host, buying a house with a grill in the yard, or just want to know where things stand.
Most homes need a deep clean every 6 to 12 months. If you grill several times a week, lean toward 6.
If you would rather not keep track, the Protection Plan membership puts your cleanings on a schedule and we come back when they are due.
Wear and tear
What wears grills out in Atwood
Atwood is inland, so salt air is not the main enemy. Heat, dust and spiders are. Dust and debris settle in burner ports, and spiders like the venturi tubes, which are warm and sheltered.
Together those cause most of the weak flames, hot spots and no-light problems we get called for. A regular cleaning that clears the ports and tubes prevents most of them.
When it's time to replace
New grills: measured, installed, old one hauled away
Sometimes repair does not make sense. The firebox is rusted through, parts are no longer made, or the repair would cost more than the grill is worth. We tell you when that is the case.
If you decide to replace it, we measure the cutout or the space, sell you a grill that fits, install it, and haul the old one away. For a built-in, getting the measurement right is the difference between a clean fit and a countertop that has to be recut.

What to expect
What a visit in Atwood looks like
- You book online and tell us what the grill is doing, with a photo of the model label if you have one.
- The technician arrives in the scheduled window and looks at the grill with you.
- We explain what we found, do the cleaning or repair, and test the grill.
- We clean up our work area and go over what was done.
- You get a written report if you booked an inspection.

