Mobile service
We come to you in Capistrano Beach
Your grill gets cleaned and repaired where it stands. A technician pulls up, sets up a work area beside the grill, and does the job at your house. Nothing goes on a trailer, and nobody has to fight a greasy grill into the back of a car.
That matters most for built-ins. A grill set into a stone or stucco island is not going anywhere, and a shop can't work on it anyway. We bring the tools and the common parts to the island.
We cover Doheny Village, Beach Road, Capistrano Shores, the Palisades, Poche Beach and the streets around Capistrano Beach Park. Carts, built-ins and the grill on a small patio all get the same kind of visit.
Deep cleaning
Deep grill cleaning, start to finish
A deep clean takes the grill apart and cleans every part that touches fire, food or grease. Here is what is included:
- Cooking grates, scrubbed and scraped clean
- Burners, with every port cleared
- Heat plates or flavorizer bars
- Briquette trays and the briquettes in them
- Firebox, scraped out from the bottom up
- Drip tray and grease management system, emptied and cleaned
- Igniter electrodes, cleaned and checked for a good spark
- Hood and outside stainless, degreased and wiped down
- Cleanup of our work area when we finish
Buildup is more than a mess. Grease and carbon act as fuel, so a dirty firebox feeds flare-ups and grease fires. Clogged ports give you uneven heat, with one side scorching and the other barely warm. Moisture trapped under grease starts rust, and burners that sit in that mess rot out from the outside in.

Start with the symptom
BBQ repair in Capistrano Beach
Most repairs are finished in one visit, because the truck carries common parts for most brands. These are the problems we see most often along the coast.
Grates rusting or flaking
Salt air and trapped moisture eat bare cast iron and thin plated rods. We scrub off surface rust and replace grates that are flaking into your food.
Burners rusted through
Rust starts on the underside of the tube, then holes open and the flame turns ragged. We fit a matching burner and clear the ports on the rest.
Igniter clicks but won't light
Usually a corroded electrode tip, a loose wire or a dead battery or module. We clean or replace the part and test the spark.
Knobs seized or spinning
A rusted valve stem locks the knob in place, while a worn knob can spin without opening the gas. We free or replace the stem, valve or knob.
Hood hinges and handles corroding
Salt turns hinges stiff and handles loose, and the hood stops sitting right. We replace the worn hardware so the lid opens and seals properly.
Won't get past 300 degrees
The cause is often a regulator stuck in low-flow mode, clogged ports or a failing valve. We check pressure first, then work back to the burners.
One burner is weak
Blocked ports, spider webs in the venturi tube or a tired valve are the usual causes. We clear it, test it, and replace whatever has failed.
Smells like gas
Shut the gas off at the tank or the supply valve and do not light the grill until it has been checked. Leaks usually come from a cracked hose, a loose fitting or a worn valve, and we leak-test each connection.
Repair it right
We diagnose before you buy parts
The same symptom can have several causes. A grill that won't light might need a battery, an electrode, a regulator or a clean burner. We find the cause first, so you only pay for parts that fix the problem.
Before we come, take a photo of the label with your grill's model and serial number. It lets us bring the right parts. The truck carries parts for most brands, and more are available at store.progrill.com, including parts for most built-in grills.
Built-ins & outdoor kitchens
Built-in grills and outdoor kitchens
When one part fails on a built-in, repair usually makes more sense than replacement. The island, the cutout and the gas line are already in place, and a burner, valve or igniter swap gets the grill working again without touching any of it.
We also design, fabricate and repair outdoor kitchens. That covers islands, counters, doors, drawers and the grill setup inside them.
Smokers, griddles, pizza ovens, fireplaces and fire pits get the same on-site service.

Inspections & maintenance
Inspections and regular maintenance
A grill inspection is a full check of the gas connections, burners and ignition, followed by a written report. You see what is worn, what is fine and what to watch, with nothing hidden in the details.
Most homes should have a deep cleaning every 6 to 12 months. If you grill several times a week, lean toward the shorter end.
The Protection Plan is a membership for scheduled cleanings, so the work happens on a calendar instead of after something goes wrong. We have 2,500+ five-star reviews (Google, Yelp and Facebook) and over 25,000 grills serviced, and our team has 50+ years of combined grill experience.
Wear and tear
What wears grills out in Capistrano Beach
Close to the ocean, salt air is the main enemy. It rusts burners, grates and hardware faster than inland air does, and it corrodes igniter tips until the spark gets weak.
Stainless gets surface rust and staining if it is never wiped down. A regular cleaning and a quick wipe after cooking slow it down.
When it's time to replace
New grills, measured, installed and hauled away
Sometimes repair stops making sense, such as a rusted-out firebox or a grill that costs more to fix than it is worth. In that case we measure the cutout, sell you a new grill that fits, install it and haul the old one away.

What to expect
What a visit looks like
- You book online and tell us what the grill is doing.
- The technician arrives and goes over the grill with you.
- We clean, repair or inspect on site, working in one area.
- We test the grill before we pack up.
- We clean up our work area and walk you through what we found.

