Mobile service
We Come to You in El Monte
Pro Grill is a mobile service. A technician drives to your house, sets up next to the grill, and does the work right there. Nothing goes in your trunk, and nobody has to haul a greasy grill to a shop.
This matters most for built-ins. A grill set into a block island or stone counter is not coming out, and it should not have to. We work on it where it sits and cover the surrounding area so your patio stays clean.
We serve Downtown El Monte, Mountain View, Cherrylee, Valle Lindo, Legg Lake, Flair Park and the streets around them. Since 2018 we have serviced more than 25,000 grills, and we have 2,500+ five-star reviews (Google, Yelp and Facebook). Our team has 50+ years of combined grill experience, and we are insured.
Deep cleaning
Deep Grill Cleaning, Start to Finish
A deep clean is not a quick brush-down. We take the grill apart, clean every piece, and put it back together so it lights and heats the way it should. Here is what is included:
- Cooking grates scrubbed and cleaned
- Burners cleaned, with ports cleared
- Heat plates or flavorizer bars cleaned or checked for wear
- Briquette trays emptied and cleaned
- Firebox scraped out, bottom and sides
- Drip tray and grease management cleaned
- Igniter electrodes cleaned and tested
- Hood and outside stainless cleaned and wiped down
- Our work area cleaned up when we finish
Old grease and carbon are fuel. They cause flare-ups, plug burner ports so the heat runs uneven, and hold moisture against metal until it rusts. Left alone long enough, they eat burners from the outside until they rot out. Cleaning also shows us what is wearing out, so you hear about it before it fails mid-cookout.

Start with the symptom
BBQ Repair in El Monte: Common Problems We Fix
Most repairs are finished on the first visit. These are the problems we see most often.
Igniter clicks but the grill won't light
Usually a dirty or cracked electrode, a loose wire, or a dead module. Sometimes it is only a blocked burner port or low gas flow.
Low heat
A grill that never gets hot enough often has a failing regulator, a clogged burner or a partly closed valve. We test the gas supply before touching anything else.
Uneven or yellow flames
Yellow, lazy flames point to blocked ports or spider webs in the venturi tubes. Hot spots on one side usually mean a burner that is corroded or clogged.
Burners rusted through
Once a burner has holes or flaking metal, cleaning will not fix it. We replace it with the right part for your model.
Sticking or leaking valves
A knob that is stiff, loose or won't shut off completely should be looked at promptly. We test for leaks and replace valves and knobs as needed.
Worn grates
Chipped porcelain, thin rods and heavy rust make food stick and cook unevenly. New grates fix that fast.
Briquette trays and heat shields
These burn out slowly, and the damage often goes unnoticed until the grill runs hot in one spot. We replace them and check what is underneath.
Ignition modules and wiring
If the spark is weak or missing across every burner, the module or battery pack is a likely cause. We test it and swap it if it has failed.
Rotisserie motors and grill lights
A motor that stalls or a light that stays dark is usually a worn part or bad connection, and both are repairable.
Repair it right
We Diagnose Before You Buy Parts
One symptom can have several causes. A grill that will not light might need an electrode, a module, a regulator or just a good cleaning. Guessing means paying for parts you did not need, so we check first and fix what is actually wrong.
When you book, take a photo of the label with the model and serial number. It is usually on the frame, inside a cabinet door or on the back panel. That lets us come with the right parts.
Our trucks carry parts for most brands. For anything we do not have on board, parts for most built-in grills are available at store.progrill.com.
Built-ins & outdoor kitchens
Built-In Grills and Outdoor Kitchens in El Monte
When one part fails on a built-in, repair is almost always the better call. The island, the cutout and the gas line are the expensive part, and the grill head in them is usually sound. A new burner, valve or igniter gets it back to work without tearing out the counter.
We also design, fabricate and repair outdoor kitchens: islands, counters, cabinet doors, side burners and the gas and electrical connections behind them. If you want to add to what you have, we can plan it with you.
Beyond grills, we service smokers, griddles, pizza ovens, fireplaces and fire pits.

Inspections & maintenance
Grill Inspections and Regular Maintenance
An inspection is a full check of the gas connections, burners and ignition system, and we put what we find in a written report. It is useful if you are buying or selling a home with a grill, or if you want to know what shape yours is in before summer.
Most homes should clean a grill every 6 to 12 months. If you cook on it several times a week, plan on the shorter end.
The Protection Plan is a membership for scheduled cleanings. We set the schedule, then show up on time, so you do not have to remember. Ask when you book and we will explain how it works.
Wear and tear
What Wears Grills Out in El Monte
El Monte is inland, so salt air is not the usual problem. Heat and dust are. Dust and debris settle in the grill, and spiders like to build nests in the venturi tubes, the small tubes that feed gas to each burner.
A blocked tube starves a burner, which gives you weak, yellow or uneven flames and sometimes flames at the back of the burner. A cleaning that clears the tubes fixes it, and it is worth doing again after a long stretch of the grill sitting unused.
When it's time to replace
New Grills: Measuring, Installing, Hauling Away
Sometimes repair does not make sense, such as a rusted-out firebox or a model with no parts left. In that case we measure your cutout, help you pick a grill that fits, sell it, install it and haul the old one away.

What to expect
What a Visit Looks Like
- You book, and we confirm a time window.
- The technician arrives and looks over the grill with you.
- We explain what we found and what it needs before starting repairs.
- We clean, repair or both, on site.
- We light the grill and test it before we leave.
- We clean up our work area and go over the results with you.

