Mobile service
We come to you in Surfside
Nobody should have to load a greasy grill into a car. Our technician arrives at your house with the tools, cleaning supplies and common parts, and does the work at the grill. That covers Surfside Colony and the beach communities around it, including Sunset Beach, Old Town Seal Beach, Anaheim Landing, Huntington Harbour and Leisure World.
On-site service matters most for built-in grills. A built-in is fixed into masonry or a stainless island and can't be taken to a shop, so the work happens in your backyard or on your patio. Freestanding grills, smokers and carts get the same treatment.
We have 2,500+ five-star reviews (Google, Yelp and Facebook), and our team has more than 50 years of combined grill experience.
Deep cleaning
Deep grill cleaning
A deep clean is a full teardown, not a wipe and a scrape. Here is what we go through:
- Cooking grates, scrubbed and rinsed
- Burners, cleaned and cleared of blocked ports
- Heat plates or flavorizer bars
- Briquette trays and briquettes
- The firebox, scraped out down to bare metal
- Drip tray and grease management, emptied and cleaned out
- Igniter electrodes, cleaned so they spark where they should
- The hood and outside stainless, cleaned and polished
- Cleanup of our work area when we finish
Old grease and carbon are more than a mess. Built-up grease feeds flare-ups. Clogged ports give you uneven heat, with one side of the grill burning food while the other barely cooks it. Moisture trapped under buildup speeds up rust, and burners that sit in that mix eventually rot out. A clean grill costs less to run and its parts last longer.

Start with the symptom
BBQ repair in Surfside
Most grill problems come from a short list of worn or corroded parts. These are the ones we see most near the ocean, with what usually causes each and what we do about it.
Knobs that won't turn
Rust and old grease seize the valve stem. We free it up, clean it and replace the knob or valve if it is past saving.
Grates flaking or rusting
Bare steel and cast iron rust quickly in damp coastal air, and the coating eventually peels. We tell you if cleaning will do or if new grates are the better call.
Burners rusted through
Salt and moisture eat burners from the outside in, leaving holes and uneven flames. We replace the burner and check the ports around it.
Igniter clicks but won't light
A corroded electrode tip, a loose wire or a dead module usually sits behind this. We test the spark, clean or replace what failed and confirm the burner catches.
Hood hinges and handles corroding
The hood sticks, wobbles or won't stay open. We replace worn hinges, handles and hardware so the lid works again.
One burner is weak
Clogged ports, a spider nest in the tube, or a failing regulator are the usual causes. We clear the blockage or replace the part we find.
Won't stay lit
A low flame that goes out often points to a regulator problem, a dirty burner or a weak gas valve. We check flow at each stage and fix the weak point.
Smells like gas
Shut the gas off at the tank or the supply valve and don't light the grill until it has been checked. We test the hoses, fittings and valves, and replace whatever is leaking.
Repair it right
Diagnose first, then buy parts
The same symptom can come from different causes. A weak flame could be a clogged burner, a stuck regulator or a bad valve, and swapping parts at random wastes money. We find the cause first and replace only what is actually broken.
It speeds things up if you take a photo of the label with the model and serial number before we arrive. The truck carries parts for most brands, and more are available at store.progrill.com for built-in grills and others.
Built-ins & outdoor kitchens
Built-in grills and outdoor kitchens
When one part of a built-in fails, repair almost always makes more sense than replacing the whole grill. Burners, igniters, valves and heat plates can be swapped without touching the island. Tearing out a good cutout and countertop for one bad part rarely pays off.
We also design, fabricate and repair outdoor kitchens: islands, cabinets, countertops and the grill setup inside them. And we work on smokers, griddles, pizza ovens, fireplaces and fire pits.

Inspections & maintenance
Inspections and regular maintenance
A grill inspection is a full check of the gas connections, burners and ignition system, and you get a written report. It shows what is working, what is wearing out and what to fix first. It is useful before a party season, after a grill has sat unused, or when buying a home with a built-in.
Most homes should have the grill cleaned every 6 to 12 months, and more often if you grill a lot. The Protection Plan membership puts those cleanings on a schedule, so you don't have to remember to call.
Wear and tear
What salt air does to grills in Surfside
Being this close to the ocean is hard on grills. Salt in the air settles on burners, grates and stainless steel and speeds up rust. It also corrodes igniter tips, which is why a grill that sparked fine last summer may click without lighting now.
Regular cleaning removes the salt film before it eats into the metal, and a cover helps. Even stainless steel can pit and stain here, so we check the hood, hinges and hardware at every visit.
Start with the symptom
New grills when repair doesn't make sense
Sometimes a grill is too far gone: rusted firebox, failed burners and valves, parts no longer made. When that is the case we say so. We measure your cutout or patio space, sell you a new grill, install it and haul the old one away.

What to expect
What a visit looks like in Surfside
- You book online, and we confirm a time window.
- The technician arrives and looks over the grill, then talks through the work with you.
- We clean, repair or inspect, depending on what you booked.
- If a repair is needed beyond the original request, we explain it before starting.
- We clean up our work area and show you what was done.
Book a visit and we will come to you.

