Mobile service
We come to you in East Irvine
Your grill gets cleaned and repaired where it sits, in your backyard or on your patio. Nothing goes on a trailer, nothing gets dropped at a shop, and you don't wait a week to get it back.
That matters most for built-ins. A grill set into a stone or stucco island can't be moved, so the work has to happen at the house. We cover Portola Springs, Orchard Hills, Stonegate, Woodbury, Oak Creek, Quail Hill, Turtle Ridge, Turtle Rock, Shady Canyon, Northwood, Eastwood and Cypress Village, along with the streets around them.
Freestanding gas grills, carts and charcoal setups are just as welcome. If it cooks outside at your house, we can usually work on it there.
Deep cleaning
Deep grill cleaning
A deep cleaning goes well past a quick brush-down. We take the grill apart, clean each piece and put it back together working.
- Cooking grates, scrubbed and checked for rust or cracks
- Burners, with ports cleared and tubes checked
- Heat plates or flavorizer bars
- Briquette trays and ceramic or lava rock
- Firebox, scraped out from top to bottom
- Drip tray and grease management system
- Igniter electrodes, cleaned and tested
- Hood interior and outside stainless steel
- Cleanup of our work area when we finish
Buildup is more than a looks problem. Old grease feeds flare-ups and can catch fire in the firebox. Clogged ports give you uneven heat, with one side scorching and the other barely warm. Wet grease and ash hold moisture against metal, so rust starts, and burners rot out years sooner than they should.
A cleaning won't fix parts that are worn out. If something is past saving, we tell you and show you what we found.

Start with the symptom
BBQ repair at your door
Most grill trouble comes down to a handful of parts: burners, valves, igniters, grates, briquettes, heat plates, knobs and regulators. These are the problems we see most in East Irvine yards.
Igniter clicks but won't light
Usually a dead battery, a dirty or misaligned electrode, or a cracked igniter wire. We test the spark, then clean, adjust or replace what's failing.
Flame is low or weak
Often the regulator has gone into low-flow (bypass) mode, which limits gas to a trickle. We reset or replace it and confirm the grill reaches full heat.
Yellow, lazy flames
Spiders love venturi tubes, and a nest blocks the gas and air mix. We clear the tubes and clean the burner so the flame burns blue again.
Flare-ups and grease fires
Grease built up on heat plates, trays and the firebox is the fuel. We strip it out, check that the drip system drains, and replace any heat plates that no longer shield the burners.
One burner is weaker than the rest
Dust and debris in the burner ports, or a burner with a split seam, are the usual causes. We clean the ports, and replace the burner if it's damaged.
Heat shields burned through
Briquette trays and heat shields wear thin from years of grease and high heat. Once they have holes, they stop spreading heat evenly. We fit new ones sized to your grill.
Smells like gas
Shut the gas off at the tank or the line and don't light the grill until it's checked. We test the hoses, fittings, valves and regulator, and fix the leak before the grill is used again.
Knob spins without turning on the gas
The knob has slipped on the valve stem, or the stem itself is worn. We replace the knob or the valve, depending on what's stripped.
Repair it right
We diagnose before we buy parts
The same symptom can come from different problems. A weak flame might be a regulator, a blocked tube or a dirty port. Swapping parts by guesswork costs you money and fixes nothing, so we check first and replace only what's actually failing.
If you can, take a photo of the label with the model and serial number and send it when you book. It lets us bring the right parts the first time. The truck carries parts for most brands, and a wider selection is available at store.progrill.com for built-in grills and for owners who want to do the swap themselves.
Built-ins & outdoor kitchens
Built-in grills and outdoor kitchens in East Irvine
When one part fails on a built-in, repair is almost always the better call. The grill is already sized to the island, wired and plumbed, and the stonework around it stays put. A new burner, valve or igniter costs far less than tearing out a cutout and starting over.
We also design, fabricate and repair outdoor kitchens: islands, counters, doors, drawers, and the fittings that go with them. If your setup has a side burner, a griddle or a pizza oven, we can look at those on the same visit.
Beyond grills, we work on smokers, griddles, pizza ovens, fireplaces and fire pits.

Inspections & maintenance
Inspections and regular maintenance
A grill inspection is a full check of the gas connections, burners and ignition. You get a written report listing what's working, what's wearing and what needs attention, which is useful before a big cookout, a home sale or a long stretch of heavy use.
Most homes do well with a cleaning every 6 to 12 months. If you grill several times a week, plan on the shorter end.
The Protection Plan is a membership for scheduled cleanings, so the grill gets looked after without you having to remember to call.
Wear and tear
What wears grills out in East Irvine
East Irvine sits inland, so salt air isn't the main enemy here. Heat and dust do most of the damage. Grills that sit in direct sun, or get used hard through the warm months, burn through heat shields and briquette trays faster, and dust settles into burner ports and works into the tubes.
Spiders are the other regular culprit. They build nests in the venturi tubes, block the gas, and leave you with weak or yellow flames. A cover and a cleaning every season go a long way.
When it's time to replace
New grills, measured, installed and hauled away
Sometimes repair doesn't add up: the firebox is rusted through, the frame is warped, or parts are no longer made. In that case we measure your cutout or patio space, recommend a grill that fits, install it and haul the old one away.
For built-ins, the measurements matter. A grill that's a half inch too wide won't drop into the island, so we get those numbers right before anything is ordered.

What to expect
What a visit looks like
- You book online and tell us the grill type, the problem and, if you have it, the model number.
- A technician arrives in the window we give you.
- We look the grill over and tell you what we find before starting work.
- We clean, repair or both, working in a protected area near the grill.
- We test the grill, then clean up our work area.
- You get a clear explanation of what was done and what to watch for next. Our work is backed by 2,500+ five-star reviews (Google, Yelp and Facebook).

