Mobile service
We come to your Chatsworth home
Pro Grill is a mobile service. The technician arrives with tools, cleaning gear and parts, and the work happens next to the grill. Nobody has to wrestle a greasy grill into a car or leave it at a shop for a week.
This matters most for built-ins. A grill set into a stone or stucco island is not coming out for a cleaning, and it shouldn't have to. We work in place, protect the ground and counters around it, and leave the area tidy.
We service homes across Chatsworth, including Chatsworth Lake Manor, Browns Canyon, Oakridge Estates, Old Chatsworth, Chatsworth Woods and Dayton Canyon. If your street isn't named here, tell us when you book and we'll confirm we can get to you.

Deep cleaning
Deep grill cleaning
A deep cleaning is not a quick scrub of the grates. We take the grill apart to the firebox and clean what you can't reach with a brush at home. Here is what is included:
- Cooking grates, scraped and washed
- Burners, cleaned and the ports cleared
- Heat plates or flavorizer bars
- Briquette trays
- Firebox, scraped out from top to bottom
- Drip tray and grease management system
- Igniter electrodes, cleaned and checked
- Hood and outside stainless, wiped and polished
- Cleanup of our work area when we're done
Buildup is more than a looks problem. Old grease feeds flare-ups and can catch fire inside the cabinet. Carbon and drippings clog burner ports, so heat comes out uneven and one side of the grill runs cold. Wet grease and ash hold moisture against metal, which starts rust, and burners that sit in that mess rot out years early. A cleaning will not fix a burner that is already failing, but it slows the damage and lets us spot weak parts before they fail.

Start with the symptom
BBQ repair in Chatsworth
Most grill problems come down to a handful of parts: burners, valves, igniters, regulators, grates, heat plates and briquette trays. We repair all of them, plus knobs and lights. These are the problems we see most often.
Spiders and nests in the burner tubes
Spiders love the venturi tubes, the short pipes that feed gas to each burner. A web or nest blocks the flow, so you get a weak flame, a flame that burns at the back of the tube, or a grill that won't light. We pull the burners, clear the tubes and check for gas flashback damage.
Flare-ups and grease fires
Flames leaping above the grates mean grease has built up on the heat plates, in the firebox or in the drip tray. We clean it out, replace plates that are burned through, and tell you what to change at home.
Weak flame, low heat
If every burner is low, the regulator has often slipped into low-flow bypass mode, usually after the gas was opened too fast. We reset or replace it and test the flame on every burner.
Hot spots and uneven heat
Clogged burner ports, warped heat plates or a bent burner are the usual causes. We clear or replace what's damaged and check that the flame is even across the whole grill.
Igniter clicks but won't light
The spark is weak, the electrode is dirty or cracked, or the wire has failed. Sometimes the battery or module is the culprit. We test each piece instead of swapping them all.
Smells like gas
Shut the gas off at the tank or the valve and do not light the grill until it's been checked. Leaks usually come from a worn hose, a loose fitting or a cracked valve, and we pressure-check the connections to find it.
Won't get past 300 degrees
This points to a regulator problem, a partly blocked burner or a bad hose. We find out which and fix it, so the grill reaches searing temperature again.
Burned-through briquette trays and heat shields
These parts take the heat and drippings, so they wear out first. Holes mean flare-ups and uneven cooking. We replace them with the right fit for your model.
Repair it right
We diagnose first, then buy parts
The same symptom can have different causes. A grill that won't light might need an electrode, a regulator, a valve or just a cleaned burner. Guessing means paying for parts you didn't need, so we check the grill before replacing anything.
When you book, take a photo of the label with the model and serial number. It is usually on the frame, inside the cabinet door or near the gas inlet. With that we can look up the exact parts before the truck leaves.
The truck carries parts for most brands, so many repairs are finished in one visit. If a part has to be ordered, you can find parts for most built-in grills at store.progrill.com.
Built-ins & outdoor kitchens
Built-in grills and outdoor kitchens
When one part fails in a built-in, repair is usually the smarter move. The grill head is often solid stainless, and the island around it cost far more than the burner or valve that quit. Replacing a grill means cutting, fitting and sometimes rebuilding the cabinet. Replacing the part takes an hour or two.
We also handle the outdoor kitchen itself: design, fabrication and repair. That covers new islands, access doors, drawers, side burners and refrigerator cutouts, along with repairs to the ones you already have.
Our technicians also work on smokers, griddles, pizza ovens, fireplaces and fire pits, so a single visit can cover more than the grill.
Inspections & maintenance
Grill inspections and regular maintenance
An inspection is a full check of the gas supply, burners and ignition system, with a written report. It is useful before a big cookout, when you've bought a house with a grill in the yard, or any time you aren't sure what shape the grill is in. You get a plain list of what's fine, what's wearing and what needs work.
Most homes should have a deep cleaning every 6 to 12 months. If you grill several times a week, lean toward every 6.
The Protection Plan is a membership for scheduled cleanings. We come on a regular timetable, so you don't have to remember. We have 2,500+ five-star reviews (Google, Yelp and Facebook), and we've serviced over 25,000 grills.
Wear and tear
What wears grills out in Chatsworth
Chatsworth is inland, so salt air is not what kills grills here. The common trouble is heat and dust. Long hot stretches bake grease onto heat plates and burners, and fine dust settles into burner ports and the gas intake.
Spiders are the other regular culprit. They build in the venturi tubes, especially in grills that sit unused for a few weeks. A cover helps, and a yearly cleaning clears out whatever got in anyway.
When it's time to replace
New grills, measured, installed and hauled away
Sometimes repair doesn't make sense: the firebox has rusted through, the frame is warped, or parts are no longer made. In that case we can sell you a new grill.
For a built-in, we measure the cutout first so the new grill fits the island. Then we install it, connect the gas and test it, and haul the old grill away.

What to expect
What a visit looks like
- You book a time and tell us what the grill is doing.
- The technician arrives and checks the grill before touching anything.
- We explain what we found and what it will take to fix.
- We clean, repair or both, working at the grill.
- We test the flame and ignition, then clean up our work area.

