Mobile service
We come to you in West Hills
Pro Grill is a mobile service. A technician drives to your house, works in your backyard or on your patio, and leaves the grill right where it lives. Nothing gets loaded into a truck bed and nothing sits in a shop for a week.
That matters most for built-in grills. A built-in is set into masonry or a stainless frame and isn't going anywhere, so the work has to happen on site. Freestanding and cart grills get the same visit, and you skip wrestling a greasy grill into the car.
We cover Platt Ranch, Valley Circle Estates, Dayton Canyon, Sherwood Forest, Fallbrook, Woodlake and the streets around them. Pro Grill started in Southern California in 2018, has serviced more than 25,000 grills, and now works in Arizona too. Our team has 50+ years of combined grill experience, and we're insured. We have 2,500+ five-star reviews (Google, Yelp and Facebook).
Deep cleaning
Deep grill cleaning, start to finish
A deep cleaning is not a quick scrape of the grates. We take the grill apart, clean each piece, and put it back together working. Here is what's included:
- Cooking grates, scrubbed and cleared of baked-on residue
- Burners, cleaned and checked, with the ports cleared
- Heat plates or flavorizer bars
- Briquette trays and the firebox
- Drip tray and grease management, emptied and cleaned out
- Igniter electrodes, cleaned so they spark where they should
- Hood interior and the outside stainless
- Cleanup of our work area when we're done
Buildup is more than a looks problem. Old grease feeds flare-ups and can catch in the drip tray. Clogged ports give you uneven heat, with one side searing and the other barely warm. Moisture trapped under carbon and grease speeds up rust, and burners that sit in that mess rot out sooner than they should.

Start with the symptom
BBQ repair
Most repairs are finished in one visit, because the truck carries common parts for most brands. These are the problems we see most often at West Hills homes.
Hot spots and uneven heat
Usually blocked burner ports, a warped heat plate, or a burner that's sitting off its valve. We clean the ports, replace what's bent or burned, and reseat the burners.
Spider nests in the venturi tubes
Spiders love the burner tubes, and a nest chokes the gas and air mix. You'll see weak or yellow flames, or flames that start behind the knobs. We clear the tubes, clean the burners, and check the flame afterward.
Low flame, weak heat
Often the regulator has slipped into low-flow bypass mode, which happens after a sudden gas surge or when a tank valve is opened too fast. We reset it, or replace it if it won't hold, and test the flame at each burner.
Igniter clicks but won't light
The cause is a dirty or cracked electrode, a loose wire, a dead battery, or a failed igniter module. We trace which one, then replace only that part.
Smells like gas
Shut the gas off at the tank or valve and don't light the grill until it's been checked. We test hoses, fittings and valves for leaks, then fix or replace what's failing.
Grill won't stay lit
This points to a regulator problem, a weak gas supply, or a burner that is partly clogged. We check pressure and flow first, then clean or replace the part at fault.
Burned-through heat shields and briquette trays
Grease fires and years of heat eat thin metal. Once a tray or shield has holes, the heat stops spreading evenly. We cut to the right replacement and fit it.
Repair it right
We diagnose before we buy parts
One symptom can come from several causes. A weak flame might be a dirty burner, a bad regulator or a failing valve. Guessing means paying for parts you didn't need, so we check first and replace only what the test points to.
If you're booking, take a photo of the model and serial number label on your grill, usually inside a cabinet door, on the frame, or under the control panel. It lets us bring the right parts the first time. The truck carries parts for most brands, and more are available at store.progrill.com for built-ins and other grills.
Built-ins & outdoor kitchens
Built-in grills and outdoor kitchens in West Hills
When one part fails on a built-in, repair almost always beats replacement. The grill is fitted to a cutout, tied into gas, and surrounded by stone or tile. Swapping a burner, valve or igniter costs far less trouble than tearing into the island.
We also design, fabricate and repair outdoor kitchens: islands, cabinets, doors, drawers and counter layouts. And we work on smokers, griddles, pizza ovens, fireplaces and fire pits, so one company can look after everything on the patio.

Inspections & maintenance
Inspections and regular maintenance
A grill inspection is a full check of the gas connections, burners and ignition, with a written report of what we found. It's useful before a big cookout season, when buying a house with a built-in, or any time you're unsure about an older grill.
Most homes should have a deep cleaning every 6 to 12 months. If you grill several times a week, lean toward every 6.
The Protection Plan is a membership for scheduled cleanings, so the visit lands on your calendar without you having to remember it.
Wear and tear
What wears grills out in West Hills
West Hills sits inland, so the trouble isn't salt. It's heat, dust and spiders. Hard summer use bakes grease onto burners and trays, and dust settles into burner ports and slowly narrows the flame.
Spiders are the other regular culprit. They build in the venturi tubes, block the gas and air mix, and cause weak flames and flashback. A clean-out before the busy season catches most of it.
When it's time to replace
New grills, measured, installed and hauled away
Sometimes repair stops making sense: the firebox is rusted through, the frame is failing, or parts are no longer made. Then we measure your cutout, sell you a grill that fits, install it, and haul the old one away.

What to expect
What a visit looks like
- You book online and tell us what the grill is doing, with a photo of the label if you can
- The technician arrives in the window we gave you and looks over the grill
- We diagnose, explain what we found, and do the cleaning or repair on the spot
- We test the flame, the ignition and the gas connections before we pack up
- We clean our work area and leave you with a summary of the work

