Mobile service
We come to you in Canoga Park
Our technicians drive to your house with tools, cleaning supplies and common parts on the truck. The work happens in your yard or on your patio. You don't load a greasy grill into the car, and you don't wait at a shop for a burner to come in.
Built-in grills are the easiest case for us, because a grill set into a stone or stucco island can't go anywhere. We work on freestanding carts, too. We cover Warner Center, Owensmouth, Shadow Ranch, Canoga Park Town Center, Old Canoga Park and the blocks around Sherman Way.
Pro Grill started in Southern California in 2018 and has serviced over 25,000 grills. We have 2,500+ five-star reviews (Google, Yelp and Facebook), the team has 50+ years of combined grill experience, and we're insured.
Deep cleaning
Deep BBQ grill cleaning
A deep cleaning goes well past a quick scrape of the grates. We take the grill apart, clean each piece and put it back together. A visit includes:
- Grates scrubbed and cleaned on both sides
- Burners cleaned, with the ports cleared of carbon and debris
- Heat plates or flavorizer bars cleaned or flagged if they're worn through
- Briquette trays emptied and cleaned
- Firebox scraped out, including the corners where grease cakes up
- Drip tray and grease management system cleaned
- Igniter electrodes cleaned and checked
- Hood interior and outside stainless cleaned and wiped down
- Our work area cleaned up when we finish
Buildup does real damage. Grease in the firebox feeds flare-ups. Clogged burner ports give you uneven heat, with one side searing and the other barely warm. Moisture sitting under old grease starts rust, and burners that stay coated with residue rot out sooner than clean ones. A cleaning won't fix a part that's already failing, but it slows the damage and shows us what needs attention.

Start with the symptom
BBQ repair in Canoga Park
Most grill problems come down to a few parts: burners, valves, igniters, regulators, heat shields and grates. We fix those and also replace knobs, briquettes and grates. These are the problems we see most.
Burner ports are clogged
Dust, grease and bits of food block the small holes, and the flame comes out patchy. We clean the ports and the burner surface, and replace the burner if it's too far gone.
Spiders in the venturi tubes
Spiders and their nests block the tubes that feed gas to the burners. That gives you yellow flames, flames that burn at the back of the grill, or a burner that won't light. We clear the tubes and check the burner for damage.
Hot spots and uneven heat
This is usually blocked ports, worn heat plates, or a burner that's partly rusted. We find which one it is and fix that part instead of replacing the whole grill.
Flame stays low on high
A regulator stuck in low-flow (bypass) mode will do this. Sometimes resetting it fixes the problem. If not, we replace the regulator.
Smells like gas
Shut the gas off at the tank or the line and don't light the grill until it's been checked. The cause is often a worn hose, a loose fitting or a leaking valve, and we test each connection to find it.
Igniter clicks but won't light
A dead battery, a dirty or cracked electrode, or a loose wire is the usual cause. We test the igniter, then clean or replace what failed.
Heat shields and briquette trays are burned through
These parts take the most heat and wear out first. Once they go, grease reaches the burners and the heat gets uneven. We replace them with parts that fit your model.
Repair it right
We diagnose before you buy parts
The same symptom can come from different problems. A weak flame might be a clogged burner, a bad regulator or a leaking valve. Guessing at parts costs you money and time, so we check the grill first and fix what's actually wrong.
It speeds things up if you take a photo of the model and serial number label before we arrive. It's usually on the frame, inside a door or near the gas connection. The truck carries parts for most brands, and we can get more from store.progrill.com. You can also order parts for most built-in grills there yourself.
Built-ins & outdoor kitchens
Built-in grills and outdoor kitchens
When one part fails on a built-in, repair is usually the better choice. A new burner, valve or igniter costs far less than cutting out the island and starting over. We tell you plainly when a grill is past saving, but that's not the usual case.
We also design, fabricate and repair outdoor kitchens: islands, counters, doors, drawers and the grill space that goes in them. Beyond grills, we work on smokers, griddles, pizza ovens, fireplaces and fire pits.

Inspections & maintenance
Inspections and regular maintenance in Canoga Park
An inspection is a full check of the gas connections, burners and ignition system. You get a written report of what's working, what's worn and what to watch. It's useful before a party season, after a grill has sat unused, or when you're thinking about selling.
Most homes should have a deep cleaning every 6 to 12 months. If you grill several times a week, lean toward the short end. If you'd rather not keep track, the Protection Plan membership puts scheduled cleanings on the calendar for you.
Wear and tear
What wears grills out here
Canoga Park is well inland, so salt air isn't the problem. Heat is. Grills in the Valley sit in the sun for months, and that dries out hoses, wears igniters and bakes grease onto the firebox.
Dust and spiders do the rest. Dust settles in burner ports, and spiders like the venturi tubes, especially on a grill that sits for a while. A cover and a regular cleaning prevent most of it.
When it's time to replace
New grills, measured, installed and hauled away
Sometimes repair doesn't make sense: the firebox is rusted through, the frame is bent, or parts for the model are gone. In that case we measure your cutout or patio space, sell you a new grill that fits, install it and haul the old one away.

What to expect
What a visit looks like
- You book online or by phone and tell us the grill type and what's wrong.
- A technician arrives at your Canoga Park home and looks over the grill with you.
- We confirm what needs doing before we start.
- We clean, repair or both, working at the grill.
- We test the grill, clean up our work area and go over what we found.

