Mobile service
We Come to You in Calabasas
Pro Grill is a mobile service. A technician drives to your home in Calabasas with tools and parts, and the work happens right at the grill, on your patio or at your outdoor kitchen. Nothing greasy gets loaded into a truck and hauled to a shop.
That matters most for built-ins. A grill set into a stone or stucco island is not coming out for a cleaning, and it shouldn't have to. We work in place, from Old Town Calabasas to the gated streets of Park Granada and up in Mulholland Highlands, on built-ins, freestanding carts and everything between.
We have serviced more than 25,000 grills since 2018 across Southern California and Arizona, with 2,500+ five-star reviews (Google, Yelp and Facebook). The team has 50+ years of combined grill experience, and we're insured.
Deep cleaning
Deep Grill Cleaning
A deep cleaning takes the grill apart section by section and reaches the grease and carbon a wire brush never touches. Here is what we go through:
- Cooking grates, scrubbed and checked for cracks and heavy rust
- Burners, cleaned with every port cleared
- Heat plates or flavorizer bars, scraped, or flagged for replacement if burned through
- Briquette trays and what sits in them
- Firebox, scraped out on the bottom and sides
- Drip tray and grease management system, emptied and cleaned
- Igniter electrodes, cleaned and tested
- Hood and outside stainless, degreased and wiped down
- Our work area, cleaned up when we finish
Buildup is more than a mess. Grease in the firebox feeds flare-ups and grease fires. Clogged ports give uneven heat, with one side of the grill running hot and the other cold. Moisture trapped under grease and ash rusts grates and firebox walls, and burners sitting in that residue rot out early. A clean grill lights easier, cooks more evenly and holds its parts longer.

Start with the symptom
BBQ Repair at Your Calabasas Home
Most repairs are finished on the spot. These are the problems we get called for most.
Flare-ups and grease fires
Grease packed into the firebox and onto the heat plates is the fuel. We clean it out, replace burned-out heat plates and make sure the drip tray drains the way it should.
Spiders in the venturi tubes
Spiders nest in the tubes that feed gas to the burners, and webs block the flow. You get lazy yellow flames or fire showing near the knobs. We clear the tubes, clean the burners and check for damage.
Hot spots and uneven heat
Usually clogged ports, a warped burner or worn heat plates. We clear the ports, replace what's bent or burned, and check the gas pressure.
Regulator stuck in low flow
A regulator can drop into bypass mode and leave the grill barely warm. We reset it when it will reset and replace it when it won't.
Igniter clicks but won't light
A dirty or dead electrode, a loose wire or a failed module keeps the spark from reaching the burner. We test the spark, replace the bad part and light-test the grill.
Smells like gas
Shut the gas off at the tank or the line and do not light the grill until it's been checked. Leaks usually come from a worn hose, a loose fitting or a bad valve, and we test the connections and replace what failed.
Burned-through briquette trays and heat shields
Years of grease and high heat eat thin metal. We replace them with parts that fit your model so the flame is shielded and the heat spreads evenly.
Rotisserie motor not turning
A dead motor, a bad connection or a binding spit rod is the usual cause. We test the power and the motor, then replace whichever part is dragging.
Repair it right
We Diagnose Before Buying Parts
The same symptom can come from different problems. A weak flame might be a blocked tube, a tired regulator or a worn valve, and swapping the wrong part leaves you with the same grill and a new bill. So we check first: gas supply, regulator, valves, burners and ignition. Then we tell you what's wrong before we replace anything.
When you book, send a photo of the model and serial number label. It's usually on the cart, inside a door or near the gas connection. It lets us bring the right parts. Our truck carries parts for most brands, and anything unusual can be found at store.progrill.com.
Built-ins & outdoor kitchens
Built-In Grills and Outdoor Kitchens
When one part fails on a built-in, repair is almost always the better move. The island, the stonework and the gas line are the big investment. A failed burner, valve or igniter is a parts job, not a reason to rip out the kitchen.
We also design, fabricate and repair outdoor kitchens. Beyond grills, we service smokers, griddles, pizza ovens, fireplaces and fire pits.

Inspections & maintenance
Inspections and Regular Maintenance
An inspection is a full check of the gas connections, hose and regulator, burners, valves and ignition. You get a written report that says what's fine, what's wearing and what needs work. It's useful before a busy cooking season or when you're not sure what shape an older grill is in.
Most homes should have a deep cleaning every 6 to 12 months, and more often if you grill several times a week. The Protection Plan is a membership for scheduled cleanings, so the visit is on the calendar and you don't have to remember it.
Wear and tear
What Wears Grills Out in Calabasas
Calabasas is inland, so the usual trouble is heat, dust and spiders rather than salt air. Long hot stretches bake grease onto grates and firebox walls, and hard use burns through thin heat shields and briquette trays.
Dust and debris settle into burner ports, and spiders find the venturi tubes. A grill that sat covered for a few weeks can come back partly blocked. A look inside the tubes and a port cleaning before the first cookout catches most of it.
When it's time to replace
New Grills, Installed and the Old One Hauled Away
Sometimes repair doesn't make sense. The firebox has rusted through, parts are no longer made, or the repair would cost close to a replacement. Then we measure the cutout or the space, sell you a grill that fits, install it and haul the old one away.
For built-ins, measuring comes first. A grill an inch too wide will not drop into the opening.

What to expect
What a Calabasas Visit Looks Like
- You book online and pick a time, and send a photo of the model and serial label if you can.
- The technician arrives with tools and common parts and looks the grill over first.
- We tell you what we found and what we recommend before any repair starts.
- Cleaning, repair or both are done at the grill.
- If a part has to be ordered, we say so and schedule the return visit.
- We clean up our work area and go over what we did.

