Mobile service
We come to you in Malibu
Pro Grill is a mobile service. A technician drives to your house with the tools, cleaning gear and parts, and does the work right where the grill sits. You don't load up a greasy grill, drop it at a shop, or go a week without it.
This matters most for built-ins. A grill set into a stone or stucco island isn't going anywhere, so the work has to happen on site. We cover Point Dume, Paradise Cove, Carbon Beach, Malibu Colony, Broad Beach, Big Rock, Serra Retreat, Malibu Park, Trancas and Encinal Bluffs, plus the streets in between.
We started in 2018 and have serviced more than 25,000 grills across Southern California and Arizona. The team has 50+ years of combined grill experience, and we're insured.
Deep cleaning
Deep grill cleaning, start to finish
A deep cleaning is a full teardown of the cooking parts, not a brush-over. Here is what we do:
- Cooking grates scrubbed and rinsed
- Burners cleaned, with every port cleared
- Heat plates or flavorizer bars cleaned, or flagged if they're worn out
- Briquette trays and briquettes cleaned and checked
- Firebox scraped of cooked-on grease and ash
- Drip tray and grease management system emptied and cleaned
- Igniter electrodes cleaned and tested
- Hood interior and outside stainless wiped down and polished
- Our work area cleaned up before we leave
Buildup is more than a cosmetic problem. Grease feeds flare-ups. Clogged burner ports give you uneven heat and cold spots. Grease and ash hold moisture against metal, which speeds up rust, and burners that stay coated tend to rot out from the underside long before you notice.

Start with the symptom
BBQ repair at your Malibu home
Most repairs are finished in one visit, because the truck carries common parts for burners, valves, igniters, grates, briquettes, heat plates, knobs and regulators. These are the problems we see most often.
Burner rusted through
Salt air eats burner tubes from the outside in, and grease buildup speeds it along. We fit the correct replacement burner for your model and check the valves and manifold while we're in there.
Igniter clicks but nothing lights
The usual cause is a corroded electrode tip, a loose wire, or a weak module or battery. We clean or replace the electrode, check the wiring, and confirm the spark actually reaches the burner.
Grates flaking or rusting
Moisture and salt break down plated and coated grates, and the flakes end up on your food. We replace them with grates that fit your grill properly, in stainless or cast iron depending on the model.
Knobs and valve stems seized
Salt and old grease gum up valve stems until the knob is stiff or won't turn. We free the stem when we can and replace the valve when we can't.
Smells like gas
Shut the gas off at the tank or the supply valve and don't light the grill until it's been checked. Cracked hoses, loose fittings, worn regulators and leaking valves are the usual sources, and we leak-test every connection.
One burner is weak
A burner that lags behind the others typically has clogged ports, a partly blocked venturi tube or a tired valve. We clear what's blocked, test the flame, and replace the part if cleaning doesn't fix it.
Yellow, lazy flames
Healthy flames are mostly blue and stand up straight. Yellow tips point to restricted airflow, debris in the tube, or an air shutter out of adjustment, and we correct all three.
Heat shields burned through
Briquette trays and heat plates take the heat and the drippings. Once they have holes, flame and grease hit the burners directly and flare-ups follow, so we replace them with the right parts.
Repair it right
We diagnose before you buy parts
The same symptom can come from different causes. A grill that won't light could have a dead igniter, a clogged burner, an empty tank or a regulator stuck in low-flow mode. Guessing means paying for parts you didn't need, so we check first and tell you what we found.
Before the visit, take a photo of the model and serial number label. It's usually on the frame, inside a cabinet door or on the back of the grill. That lets us bring the right parts the first time.
The truck carries parts for most brands. For anything else, including parts for most built-in grills, store.progrill.com has more.
Built-ins & outdoor kitchens
Built-in grills and outdoor kitchens in Malibu
When one part fails on a built-in, repair is usually the smarter move. The island, the cutout and the gas line are already in place, and replacing the grill can mean reworking all of it. A new burner, valve or igniter gets the grill cooking again without touching the masonry.
We also design, fabricate and repair outdoor kitchens. That covers a new build as well as fixing an existing island that has stopped working the way it should.
The same visit can cover your other outdoor cooking and heat. We work on smokers, griddles, pizza ovens, fireplaces and fire pits.

Inspections & maintenance
Inspections and regular maintenance
An inspection is a full check of the gas connections, hoses, regulator, burners and ignition, finished with a written report. It's useful before a big cookout, when you've bought a home with a grill already in the yard, or when something just seems off.
For cleaning, most homes do well every 6 to 12 months. If you grill several times a week, go closer to six.
The Protection Plan is a membership for scheduled cleanings, so you don't have to remember to call. Our customers have left us 2,500+ five-star reviews (Google, Yelp and Facebook).
Wear and tear
What salt air does to a grill in Malibu
Malibu sits on the coast, and salt air is hard on grills. It rusts burners, grates and hinges faster than inland air does, pits stainless steel, and corrodes igniter tips until the spark gets weak or stops.
A cover helps, and so does regular cleaning, because grease and salt together do the most damage. Grills that get cleaned before the rust sets in generally last longer and need fewer parts.
When it's time to replace
New grills, measured and installed
Sometimes repair stops making sense, like when the firebox has rusted through or the parts cost more than the grill is worth. In that case we sell new grills, and we measure your cutout or space first so the new one fits.
We handle the install and haul the old grill away, so you aren't left with it on the patio.

What to expect
What a visit looks like
- You book online and send a photo of the model and serial number label if you have one.
- The technician arrives with tools, cleaning gear and common parts.
- We look the grill over and tell you what we find before starting repairs.
- We clean, repair or both, then test the burners and ignition.
- We clean up our work area and go over what we did.

