Mobile service
We Come to Your Oxnard Home
Pro Grill is a mobile grill service. Our technicians drive to your house in Oxnard with the tools and parts for the job, and we work on the grill right where it sits. Nobody has to load a greasy grill into a truck or leave it at a shop for a week.
That matters most for built-ins. A grill set into a stone or stucco island is not going anywhere, so the service has to come to it.
We cover Channel Islands Harbor, Oxnard Shores, Hollywood Beach, Silver Strand, Mandalay Bay, Seabridge, Northshore, RiverPark, River Ridge, College Park, Rose Park, Wagon Wheel and Downtown Oxnard, along with the streets in between. We have serviced more than 25,000 grills since 2018, and we have 2,500+ five-star reviews (Google, Yelp and Facebook).
Deep cleaning
Deep BBQ Grill Cleaning
A deep cleaning is more than a scrub of the grates. We take the grill apart, clean each part and put it back together. A full cleaning covers:
- Cooking grates, cleaned and checked for wear
- Burners, with ports cleared so the flame is even
- Heat plates or flavorizer bars
- Briquette trays and any briquettes or ceramic rods
- Firebox, scraped out from the walls to the bottom
- Drip tray and grease management, emptied and cleaned
- Igniter electrodes, cleaned so they spark where they should
- Hood and outside stainless steel, cleaned and wiped down
- Cleanup of our work area when we finish
Buildup is not only a cosmetic problem. Old grease feeds flare-ups. Clogged burner ports give you hot and cold spots across the grates. Moisture trapped under grease and ash speeds up rust, and burners that sit in that mess rot out sooner than they should.

Start with the symptom
BBQ Repair in Oxnard
Most grill problems come down to a handful of parts. We repair burners, valves, igniters, grates, briquette trays, heat plates, knobs and regulators, usually on the same visit. These are the problems we see most.
Igniter clicks but the grill won't light
The cause is often a dirty or misaligned electrode, a dead module or a loose wire. Sometimes gas is not reaching the burner at all. We test each one.
Low heat
A grill that never gets hot enough often has a regulator problem, a partly closed valve or clogged burner ports. A fresh propane tank and a clean burner rule out the easy causes first.
Uneven or yellow flames
Yellow, lazy flames mean the gas and air are out of balance. Blocked ports, a spider nest in a venturi tube or a worn burner are the usual reasons.
Burners rusted through
Holes, flaking metal and flames shooting from the wrong places mean the burner is finished. We replace it with a correct fit and check the rest of the gas path while we're there.
Sticking or leaking valves
A knob that is stiff, loose or slow to shut off needs attention. A valve that leaks gas needs it right away, so don't use the grill until we look at it.
Worn or broken grates
Thin, chipped or warped grates cause sticking and uneven searing. We replace them or, if they're sound, clean and re-season them.
Briquette trays and heat shields
These parts take the drips and the heat, so they burn through over time. A rotted tray lets grease reach the burners, so we replace it before that happens.
Ignition modules and lights
A dead module, a battery box that has corroded or a burned-out control panel light is a quick repair on most grills. We also handle rotisserie motors that have stopped turning.
Repair it right
We Diagnose Before You Buy Parts
The same symptom can come from different causes. A grill that won't light might need a new igniter, or it might need a clean electrode, a new regulator or a different tank. Replacing parts by guesswork costs money and often fixes nothing.
So we check first, then replace only what failed. If you want to move things along before we arrive, take a clear photo of the label with your grill's model and serial number. It's usually on the frame, inside a cabinet door or on the back panel.
Our trucks carry parts for most brands. When a part is not on the truck, we can order it, and many parts for built-in grills are also available at store.progrill.com.
Built-ins & outdoor kitchens
Built-In Grills and Outdoor Kitchens in Oxnard
A built-in grill is almost always worth repairing. When a burner, valve or igniter fails, replacing that one part costs far less than tearing out a grill that is sealed into stone and countertop. We do the repair in place.
We also design, fabricate and repair outdoor kitchens. That includes islands, cabinets, countertop cutouts and the gas and electrical connections that go with them. If a grill has outgrown its space or a kitchen needs a repair, we can look at the whole setup.
The same visit can cover your other outdoor cooking equipment. We service smokers, griddles, pizza ovens, fireplaces and fire pits.

Inspections & maintenance
Inspections and Regular Maintenance
A grill inspection is a full check of the gas connections, burners and ignition, finished with a written report. It tells you what is working, what is wearing out and what should be replaced, so you can decide with the facts in front of you. It is a good idea before a big cookout, after a grill has sat unused, or when you're buying a home with a grill in the yard.
Most homes need a deep cleaning every 6 to 12 months. If you grill several times a week, or cook fatty foods, go closer to six months.
If you'd rather not keep track, the Protection Plan membership puts your cleanings on a schedule. We come back when it's time.
Wear and tear
What Wears Grills Out Near the Oxnard Coast
Oxnard sits on the Pacific, and salt air is hard on grills. It rusts burners and grates faster, pits stainless steel and corrodes the tips of igniter electrodes, which is why a grill can spark weakly or not at all. The closer a grill is to the water, the faster this shows up.
Regular cleaning helps, and so does a cover when the grill is not in use. Wiping down the stainless now and then slows the damage, and an inspection catches a thinning burner before it fails in the middle of dinner.
When it's time to replace
New Grills: Measured, Installed, Old One Hauled Away
Sometimes repair does not make sense. The firebox may be rusted through, the frame may be failing, or the repairs may cost more than the grill is worth. In that case we can sell you a new grill.
For a built-in, we measure the cutout first so the new grill fits the opening. Then we install it, connect it and test it. We haul the old grill away when we leave.

What to expect
What a Visit Looks Like
- Book with the buttons on this page and tell us what the grill is doing
- A technician arrives in the window we gave you
- We look the grill over and tell you what we find
- We clean it, repair it or both, with your go-ahead
- We test the grill, clean up the work area and go over what we did

