Start with the symptom
Grill cleaning and repair at your door in Boynton Beach
Pro Grill is a mobile company. A technician comes to your house, sets up next to the grill, and does the work right there. No one hauls a greasy grill to a shop, and nothing sits in your garage for a week.
That is easiest for built-ins. A grill set into a block or stone island is not going anywhere, so we clean and repair it in place. Freestanding gas grills, cart grills and charcoal kettles get the same service on the patio, lanai or driveway.
We cover all of Boynton Beach, including Boynton Lakes, Hunters Run, Quail Ridge, Indian Spring, Canyon Lakes, Aberdeen, Valencia Reserve, the Villages of Oriole and Leisureville. If your neighborhood isn't listed, book anyway and we'll confirm.
Pro Grill started in Southern California in 2018, now works in Arizona, is growing into new areas, and has serviced more than 25,000 grills. Customers have left us 2,500+ five-star reviews (Google, Yelp and Facebook).
Deep cleaning
Deep grill cleaning
A deep clean is a full teardown, not a wipe-down with a brush. This is what a visit covers:
- Cooking grates scrubbed clean
- Burners removed, cleaned and the ports cleared
- Heat plates or flavorizer bars scraped, and flagged if they are wearing through
- Briquette trays and briquettes checked and cleaned
- Firebox scraped out, with ash and carbon removed
- Drip tray and grease management system emptied and cleaned
- Igniter electrodes cleaned and spark tested
- Hood and outside stainless degreased and wiped down
- Our work area cleaned up before we leave
Buildup is more than a mess. Old grease feeds flare-ups and can catch fire in the firebox. Carbon and drippings clog burner ports, so heat runs uneven and one side cooks slower than the other. Moisture trapped under grease and ash speeds up rust, and burners sitting in that mix rot out sooner than they should. A clean grill lights easier, holds a steadier temperature and shows you which parts are really wearing out.

Start with the symptom
BBQ grill repair in Boynton Beach
The truck carries common burners, valves, igniters, grates, briquette trays, heat plates, knobs and regulators, so many repairs are finished during the visit. These are the problems we get called for and what we do about each.
Clicks but won't light
Salt and moisture corrode igniter electrodes and tips. A dead battery or loose wire gives the same symptom. We test the spark, then clean or replace the part that failed.
Knob won't turn, or spins freely
Valve stems seize with rust, and on older grills a worn stem lets the knob slip. We free or replace the valve and fit a new knob.
Burner rusted through
Holes, flaking and ragged flames mean the burner has rotted from the outside in. We replace it and check the heat plates above it, which usually wore out at the same time.
Grates rusting or flaking
Bare cast iron and plated steel give up fast in humid air. We clean what can be saved and replace grates that are shedding flakes onto your food.
Smell of gas
Shut the gas off at the tank or the line and do not light the grill until it has been checked. Usual causes are a cracked hose, a loose fitting or a leaking valve, and we find it with a leak test.
One burner is weak
Clogged ports, a spider nest in the venturi tube or a tired valve are the usual causes. We clear or replace what is blocking the flow and test every burner.
Yellow, lazy flames
A healthy flame is mostly blue. Yellow points to a poor air mix from blocked tubes or ports, or to a regulator problem. We clean, adjust the air shutter and test the regulator.
Stuck under 300 degrees
A low-flow regulator, dirty burners and burned-through heat shields are the usual suspects. We check gas pressure first, then the burners and shields, and replace what is failing.
Repair it right
We diagnose before we sell you parts
The same symptom can have different causes. A grill that clicks and won't light might need an electrode, a module, a wire or just a battery. A weak flame might be a regulator, a blocked tube or a bad valve. We test first and replace only what failed.
Take a photo of the model and serial number label and have it ready when you book. It lets us bring the right parts. The truck carries parts for most brands, and more are available at store.progrill.com.
Built-ins & outdoor kitchens
Built-in grills and outdoor kitchens
When one part fails in a built-in, repair is almost always the better move. The cutout, the island and the gas line are the big investment, and a new burner or valve costs far less than rebuilding around a different grill.
We also design, fabricate and repair outdoor kitchens, including islands, cabinets, doors and drawers. Smokers, griddles, pizza ovens, fireplaces and fire pits get serviced too.

Inspections & maintenance
Inspections, maintenance and the Protection Plan
An inspection is a full check of gas connections, burners and ignition, followed by a written report that lists what is fine, what is wearing and what needs work. It is useful before a big cookout or when you buy a house with a grill.
Most homes should clean every 6 to 12 months, and closer to 6 if you grill often. The Protection Plan membership puts cleanings on a schedule so you don't have to remember.
Wear and tear
What wears grills out in Boynton Beach
Boynton Beach sits on the Atlantic, and salt air plus humidity are hard on grills. They rust burners, grates and stainless steel, and corrode igniter tips, valve stems and hinges, often faster than the grill's age would suggest.
Wiping down stainless, using a cover that lets moisture out, and having burners and electrodes checked once a year slows it down. Rust that has eaten through metal doesn't reverse, so catching it early keeps the repair small.
When it's time to replace
When a new grill makes more sense
Sometimes repair isn't worth it. The firebox is rusted through, the frame is failing, or parts are no longer made. In that case we measure the cutout or the space, sell you a new grill, install it, and haul the old one away.

What to expect
What a visit in Boynton Beach looks like
- You book online or by phone and tell us the grill type and the problem.
- We confirm a time window and arrive with tools and parts on the truck.
- The technician looks the grill over and explains what they find before starting.
- We clean, repair or do both on site.
- We clean up our work area and show you what we did.
- If you booked an inspection, you get the written report.

