Mobile service
We Come to You in Golf
Everything we do happens at your house. You don't load a greasy grill into the truck or drop it at a shop and wait a week. A technician pulls up, sets up a work area next to the grill, and gets started.
This matters most for built-in grills. A built-in is fixed into an island or a masonry cutout, and nobody is carrying it anywhere. We work on it in place, and for freestanding carts and portable grills we do the same thing on your patio or driveway.
We cover the Village of Golf and the neighborhoods around it, including Hunters Run, Aberdeen, Quail Ridge, Boynton Lakes and Canyon Lakes. If your street isn't named here, ask. Our Palm Beach County routes reach most of the area.
Deep cleaning
Deep BBQ Grill Cleaning
A deep cleaning takes the grill apart far beyond a brush-down of the grates. Here is what we go through:
- Cooking grates, scrubbed and rinsed
- Burners, cleaned inside and out, with the ports cleared
- Heat plates or flavorizer bars
- Briquette trays and ceramic briquettes
- Firebox, scraped down to bare metal where grease has baked on
- Drip tray and grease management system
- Igniter electrodes, cleaned so they spark where they should
- Hood interior and the outside stainless
- Cleanup of our work area when we're done
Buildup is more than an eyesore. Old grease feeds flare-ups and can catch fire inside the firebox. Carbon and grease clogging burner ports give you uneven heat, with one side searing and the other barely warm. Moisture trapped under that crust speeds up rust, and burners that sit in grease and ash rot out sooner than clean ones. Cleaning does not undo damage that has already happened, but it slows the next round of it.

Start with the symptom
BBQ Repair in Golf
Most grill problems come down to a worn part, a blocked passage or a bad connection. We fix burners, valves, igniters, grates, briquettes, heat plates, knobs and regulators, usually in one visit. These are the problems we see most around Golf.
Low heat or a weak flame
The usual causes are clogged burner ports, a partly blocked gas path or a regulator problem. We clean or replace what is restricting the flow and test the flame across every burner.
Spiders and nests in the venturi tubes
Spiders and insects like the burner tubes, and webs or nests there choke the gas and air mix. You may see flames that sputter, burn yellow, or flash back toward the knobs. We clear the tubes and check the burners for damage.
Regulator stuck in low-flow mode
If the grill fires up and then drops to a tiny flame, the regulator may have gone into bypass mode. We reset it when that works and replace it when it does not.
Flare-ups and grease fires
Flames leaping above the grates come from grease built up on the heat plates, in the firebox and in the drip tray. We clean out the fuel, replace any worn heat plates and set up the grease path so it drains properly.
Clicks but won't light
A dead battery, a dirty or corroded electrode, or a loose wire is the usual cause. Sometimes the gas isn't reaching the burner at all. We test the spark first, then the gas, and fix whichever one is failing.
Smells like gas
Shut the gas off at the tank or the supply line and don't light the grill until it has been checked. Leaks usually come from a worn hose, a loose fitting or a cracked valve, and we find the source and fix it before anything gets fired up again.
Burned-through heat shields and briquette trays
These parts take the most heat and grease, so they thin out and crack over time. Once they fail, the burners underneath get the damage. We replace them with parts that fit your model.
Rotisserie motor not turning
A seized motor, a bad plug or a worn coupling is usually the cause. We test it, then repair or replace the motor and check the spit rod for fit.
Repair it right
We Diagnose Before You Buy Parts
The same symptom can come from three different causes. A weak flame might be a clogged burner, a failing regulator or a bad valve, and ordering a part on a guess often means paying for the wrong one. We check first, then fix what is actually wrong.
To speed things up, take a photo of the model and serial number label on your grill and send it when you book. It tells us what you have, what parts it takes and what to bring. Our trucks carry parts for most brands, and we can order more from store.progrill.com, which has parts for most built-in grills.
Built-ins & outdoor kitchens
Built-In Grills and Outdoor Kitchens
When one part fails on a built-in, repairing it almost always makes more sense than replacing the whole grill. The cabinetry, the countertop and the cutout are already there, and a new burner or valve costs far less than tearing it all out. We repair built-ins on site and keep them running for years.
We also design, fabricate and repair outdoor kitchens: islands, counters, cabinet doors, drawers and the appliances in them. If your setup needs more than a burner, we can look at the whole thing.
Besides gas and charcoal grills, we work on smokers, griddles, pizza ovens, fireplaces and fire pits.

Inspections & maintenance
Inspections and Regular Maintenance
A grill inspection is a full check of the gas lines, burners and ignition. You get a written report of what we found, what is worn and what can wait. It helps before a big cookout, before buying a house with an outdoor kitchen, or when a grill has been sitting unused.
Most homes should have a deep cleaning every 6 to 12 months. If you grill several times a week, lean toward the shorter end.
The Protection Plan membership puts those cleanings on a schedule, so you don't have to remember. Ask when you book and we'll tell you how it works.
Wear and tear
What Wears Grills Out Here
Humidity and heat are the constant pressure on a grill in this part of Florida. Moisture sits in the firebox and under grease, rusting grates, burners and brackets from the inside. Heat bakes the grease on harder, and it breaks down heat shields and briquette trays faster than you'd expect.
Dust, debris and insects get into the burner ports and the venturi tubes, particularly on grills that sit idle between uses. A cover helps. A regular cleaning, plus a quick look inside the tubes before a long stretch of cooking, catches most of it.
When it's time to replace
When a New Grill Makes More Sense
Sometimes repair isn't worth it. The firebox may be rusted through, or the cost of parts may be close to a new grill. We'll tell you plainly when that is the case.
If you decide to replace it, we measure the cutout or the space, sell you a grill that fits, install it and haul the old one away. For built-ins, the measuring is the part to get right, and we do it before anything is ordered.

What to expect
What a Visit Looks Like
- You book online and tell us what the grill is doing. A photo of the model label helps.
- A technician arrives in the window we gave you and looks the grill over.
- We explain what we found and what it needs before we start.
- We clean or repair on site, using parts from the truck when we have them.
- We test the grill, clean up our work area and walk you through what we did.
We're insured, and more than 2,500+ five-star reviews (Google, Yelp and Facebook) come from homes like yours. Our team has 50+ years of combined grill experience. Book a visit and we'll come to you.

