Mobile service
We come to you in Manalapan
Your grill stays where it is. A technician arrives with the tools, the cleaning gear and a truck stocked with parts, and does the work at your house. Nobody hauls a greasy grill into a car or waits weeks at a shop.
That matters most for built-ins. A grill set into a stone or stucco island is not going anywhere, and it does not need to. We work in place, whether it sits beside the pool, on a back terrace or in a full outdoor kitchen.
We cover Point Manalapan, Plaza del Mar and the homes along A1A, on both the ocean side and the Intracoastal side. Freestanding gas grills, charcoal grills and smokers get the same visit.
Deep cleaning
What a deep cleaning covers
A deep cleaning is not a quick scrape and a wipe. We take the grill apart far enough to reach the places grease and carbon settle, then put it back together and test it. Each cleaning includes:
- Cooking grates scrubbed and cleared of baked-on residue
- Burners removed, cleaned and checked, with ports cleared
- Heat plates or flavorizer bars cleaned or flagged for replacement
- Briquette trays emptied and cleaned
- Firebox scraped out, including the corners and the bottom
- Drip tray and grease management system cleaned out
- Igniter electrodes cleaned and tested
- Hood interior and outside stainless cleaned and wiped down
- Our work area cleaned up when we leave
Buildup is more than ugly. Grease in the firebox feeds flare-ups and can turn into a grease fire. Clogged burner ports give you uneven heat, with one side scorching and the other barely warm. Moisture trapped under grease and carbon speeds up rust, and burners that sit in that mess rot out sooner. A cleaning will not undo old damage, but it slows more of it down and shows us what needs attention.

Start with the symptom
BBQ repair at your door
Most grill problems come down to a worn or corroded part, and most of those we can fix on the first visit. Here are the problems we see most often on Manalapan grills.
Stainless is pitted or stained
Salt in the air eats into stainless and leaves rust-colored spots and pitting. We clean and treat what can be saved, and tell you plainly when the damage is only surface.
Grates are rusting or flaking
Moisture and salt break down the coating on cast iron and the finish on steel rods. Light rust cleans up. Flaking grates get replaced.
Burners have rusted through
Salt air and trapped grease eat burner tubes from the outside and the inside. When you see holes or a ragged flame, we swap in a matching burner.
Knobs and valve stems are seized
Corrosion locks the stem to the valve body, and forcing the knob can snap it. We free the stem or replace the valve, and fit new knobs where needed.
Igniter clicks but won't light
Usually the electrode tip is corroded or coated in grease, or the wire has failed. We clean or replace the electrode and test the spark at each burner.
One burner is weak
Blocked ports, a partly clogged venturi tube or a failing valve can starve a single burner. We find which one it is before swapping anything.
You smell gas
Shut the gas off at the tank or the line and do not light the grill until it has been checked. Leaks usually come from a worn hose, a loose fitting or a failing valve, and we test every connection.
Repair it right
We diagnose before we buy parts
The same symptom can have several causes. A grill that won't light might need a new igniter, a clean electrode, a regulator reset or just a fresh tank. We check first, so you pay for the part that fixes it and not a guess.
It speeds things up if you take a photo of the model and serial number label before we arrive. On most grills it is on the frame, inside a cabinet door or near the gas connection. With that we can come with the right parts.
The truck carries parts for most brands, and more are at store.progrill.com if something has to be ordered. If a part is on the way, we tell you what it is and what comes next.
Built-ins & outdoor kitchens
Built-in grills and outdoor kitchens in Manalapan
When one part fails on a built-in, repair is usually the better move. The grill head is often fine, and a new burner, valve or igniter costs far less than cutting out the island and starting over. Replacing a built-in means new measurements, possible changes to the cutout and a lot more disruption.
We also design, fabricate and repair outdoor kitchens: islands, counters, access doors, drawers and the setup around the grill. If a cabinet door has swollen shut or a drawer has rusted off its track, we deal with that too.
Beyond grills, we service smokers, griddles, pizza ovens, fireplaces and fire pits. If it burns gas or wood in your yard, call us about it.

Inspections & maintenance
Inspections and regular maintenance
A grill inspection is a full check of the gas supply, the burners and the ignition system, followed by a written report. It tells you what is in good shape, what is wearing out and what to fix first. It is useful before a big gathering, when you move into a house with an existing grill, or when you are deciding whether to repair or replace.
Most homes need a deep cleaning every 6 to 12 months. If you grill several times a week, lean toward every 6. The Protection Plan membership puts scheduled cleanings on the calendar so you do not have to remember. Our 2,500+ five-star reviews (Google, Yelp and Facebook) come mostly from regular customers like these.
Wear and tear
What wears grills out near the ocean
Manalapan sits on the water, and salt air is hard on any grill. It settles on every metal surface, and with Florida humidity it keeps them damp. Burners rust from the outside in, grates lose their finish, stainless pits and igniter tips corrode until the spark stops reaching the gas.
You can slow it down. Cover the grill when it is not in use, keep the burners and firebox free of grease, and have it cleaned regularly. Even so, parts on an oceanfront grill wear faster than they would a few miles inland, and replacing burners and electrodes comes with the territory.
When it's time to replace
New grills, measured and installed
Sometimes repair stops making sense: the firebox has rusted through, the frame is failing or parts are no longer made. When that happens, we help you pick a replacement. We measure the cutout so the new grill fits, sell it, install it and haul the old one away.
You are not stuck with a grill that costs more to keep running than it is worth, and you are not left figuring out disposal.

What to expect
What a visit looks like
- You book online and tell us the grill type and what is wrong
- A technician arrives in the arranged window with tools and parts
- We look the grill over and tell you what we find before starting repairs
- We clean, repair or both, working at the grill
- We test the burners, the igniter and the gas connections
- We clean up our work area and go over what we did

