Mobile service
We come to you in Century City
Every job starts at your house. Our technicians drive to Century Woods, Century Hill, Century Towers, Moreno Highlands and the rest of Century City with the tools, cleaning gear and common parts on the truck. Nothing goes in your car, and nobody has to lift a greasy grill.
That matters most with built-ins. A grill set into an island or a stone counter is not coming out for a cleaning, and it should not have to. We work on it where it sits, on the patio, the terrace or beside the pool, and we lay down our own protection so your surfaces stay clean.
We have serviced more than 25,000 grills since 2018, and the team has 50+ years of combined grill experience. Our reviews run to 2,500+ five-star reviews (Google, Yelp and Facebook). We are insured, and we show up on the day we book.
Deep cleaning
Deep grill cleaning, start to finish
A deep cleaning is not a quick scrape of the grates. We take the grill apart to the parts where grease and carbon collect, clean each one, and put it back together working. Here is what is included:
- Cooking grates, scrubbed and rinsed
- Burners, cleaned and checked, with the ports cleared
- Heat plates or flavorizer bars
- Briquette trays and briquettes
- Firebox, scraped out from the walls to the bottom
- Drip tray and the whole grease management path
- Igniter electrodes, cleaned so they spark where they should
- Hood, and the outside stainless, wiped and polished
- Cleanup of our work area when we finish
Buildup is not only a looks problem. Old grease feeds flare-ups and grease fires. Clogged ports give you uneven heat, with one side searing and the other barely warm. Moisture sitting in caked-on residue rusts the firebox and grates. Burners that sit in that mess rot out from the inside, and replacing them costs far more than cleaning ever did.

Start with the symptom
BBQ repair at your home in Century City
Most grill problems come down to a small list of worn or dirty parts. We repair burners, valves, igniters, grates, briquettes, heat plates, knobs and regulators, usually in the same visit. These are the problems we see most.
Clicks but won't light
A dead igniter battery, a dirty or misaligned electrode, or a failed module is the usual cause. We test the spark, find the weak link and replace only that.
Flame is weak or low
Often the regulator has slipped into low-flow bypass mode, typically after the gas was turned on too fast or the tank valve was opened in a rush. We reset or replace it and check the flame across every burner.
Hot spots and cold corners
Uneven heat usually means blocked burner ports, a shifted burner or heat plates that have worn thin. We clean and realign, and swap out the plates when they are done.
Spiders in the tubes
Spiders and nests in the venturi tubes block the gas and air mix. You see yellow, lazy flames, or flames that burn at the back of the burner. We clear the tubes and check for damage.
Flare-ups
Grease on the heat plates and in the tray is the cause nearly every time. We clean it out, and we replace any parts that are soaked through or burned.
Smells like gas
Shut the gas off at the tank or the valve and do not light the grill until it has been checked. A bad hose, a loose fitting or a leaking valve is the usual source, and we find it and fix it.
Knob spins without turning on the gas
The knob has come loose from the valve stem, or the stem itself is worn. We replace the knob or the valve, depending on which one failed.
Repair it right
We diagnose before we buy parts
The same symptom can come from three different causes. A grill that will not get hot could have a bad regulator, a blocked tube or a clogged burner, and guessing wastes your money. So we check first, then fix what is actually wrong.
If you can, snap a photo of the model and serial number label before we arrive. It is usually on the frame, inside a cabinet door or under the control panel. With it, we can bring the right parts. The truck carries parts for most brands, and for built-in grills we can order more through store.progrill.com.
Built-ins & outdoor kitchens
Built-in grills and outdoor kitchens
When one part fails on a built-in, repair is nearly always the better call. The island, the countertop, the gas line and the cutout are the expensive pieces, and they are fine. A new burner, valve or igniter gets the grill working again without tearing out any of it.
We also design, fabricate and repair outdoor kitchens: islands, counters, cabinet doors, access panels and appliance cutouts. Beyond grills, we service smokers, griddles, pizza ovens, fireplaces and fire pits.

Inspections & maintenance
Inspections and regular maintenance
An inspection is a full check of the gas supply, hoses, burners and ignition, finished with a written report. It tells you what is fine, what is wearing and what needs attention soon. It is useful before the season, before a party, or when you have bought a home with a grill you know nothing about.
For cleaning schedules, most homes do well every 6 to 12 months. If you grill several times a week, or you cook a lot of fatty meat, go closer to six. The Protection Plan membership puts scheduled cleanings on the calendar so you do not have to remember them.
Wear and tear
What wears grills out in Century City
Heat and dust do most of the damage here. Burners get dusty and clogged ports follow, and grates and heat plates thin out from long hours of high heat. Gas flows less evenly and you start to notice it on the food.
Spiders are the other regular culprit. They build in the venturi tubes while the grill is covered or idle, and the first sign is often a flame that looks wrong or a burner that will not light. A cleaning and a quick check of the tubes before the season clears most of it.
When it's time to replace
New grills, measured, installed and hauled away
Sometimes repair does not make sense, such as a cracked firebox, a frame rusted through or a grill whose parts are no longer made. In that case we help you replace it. We measure the cutout, sell you a grill that fits, install it and haul the old one away.

What to expect
What a visit looks like
- You book online and tell us what the grill is doing and what model it is.
- The technician arrives in the window we gave you and looks over the grill.
- We tell you what we found and what it needs before we start the work.
- We clean, repair or both, on the spot.
- We test the grill, clean up our work area and show you what was done.

