Mobile service
We come to your Bel Air home
Cleaning and repair both happen at the house. Nobody has to load a greasy grill into an SUV or leave it at a shop for a week. The technician parks, sets up a work area beside the grill and gets started.
We cover Bel-Air Estates, Bel Air Crest, Stone Canyon, Upper Bel Air, Bel Air Glen, Roscomare Valley and the streets around them. If your property has a gate or an access code, mention it when you book so the visit starts on time.
Built-in grills are the easiest case for this. A built-in is fixed into a masonry island or cabinet, so there is no sensible way to take it anywhere. We work on it in place.
Deep cleaning
Deep grill cleaning
A deep clean goes well past a scrape of the grates. Every visit covers the following:
- Grates removed, scrubbed and checked for cracks or flaking
- Burners pulled, cleaned and inspected, with the ports cleared
- Heat plates or flavorizer bars cleaned, or flagged if they have burned through
- Briquette trays emptied and cleaned
- Firebox scraped out, bottom and sides
- Drip tray and grease management system cleaned so grease has a clear path out
- Igniter electrodes cleaned and tested
- Hood and outside stainless degreased and wiped down
- Our work area cleaned up when we finish
Buildup is more than a looks problem. Old grease and carbon feed flare-ups, clog burner ports so the heat runs uneven, hold moisture against metal until it rusts, and slowly rot burners out from the inside. Catching it early is simpler than replacing a burner that quit with guests on the way.

Start with the symptom
BBQ repair in Bel Air
We repair burners, valves, igniters, grates, briquettes, heat plates, knobs and regulators. These are the problems we get called about most.
Won't light
If the igniter clicks and nothing catches, the cause is usually a dead battery, a dirty or misaligned electrode, a worn wire, or gas not reaching the burner. We test the spark and the gas flow, then replace the part that is actually failing.
One side runs hotter
Uneven heat usually comes from clogged burner ports, a warped burner or heat plates that have worn thin. We clear the ports and replace whatever has bent or burned through.
Weak flame, stuck under 300 degrees
A grill that will not climb past 300 often has a regulator stuck in low-flow (bypass) mode. We reset or replace the regulator, then check the hose and valves behind it.
Spiders in the venturi tubes
Spiders and their nests block the tubes that feed gas and air to the burners. The flame turns yellow or weak, and fire can show up where it should not. We clear the tubes, check the burners and tell you how to keep it from happening again.
Flare-ups and grease fires
Flames jumping above the grates point to grease packed into the firebox, drip tray or heat plates. We clean it out, replace worn heat plates and make sure the grease path drains properly.
Smells like gas
Shut the gas off at the tank or supply line and do not light the grill until it has been checked. The usual causes are a loose fitting, a cracked hose or a worn valve, and we leak-test the connections to find it.
Knob spins without turning on the gas
A knob that turns freely has a worn stem or a failed valve behind it. We replace the valve or knob and confirm the burner responds across the whole range.
Rotisserie motor not turning
The motor may be burned out, jammed with grease or fed by a bad switch or cord. We test it and replace what has failed.
Repair it right
We diagnose first, then buy parts
The same symptom can have different causes. A grill that will not light might need a battery, an electrode, a module or a regulator. Guessing means paying for parts you did not need, so we check first and fix the real cause.
When you book, send a photo of the model and serial number label. It is usually on the frame, inside the cabinet or on the back of the grill. It lets us bring the right parts. The truck carries parts for most brands, and more are available at store.progrill.com for most built-in grills.
Built-ins & outdoor kitchens
Built-in grills and outdoor kitchens in Bel Air
When one part fails on a built-in, repair usually makes more sense than replacing the grill. The cutout, gas line and stonework around it stay as they are. We fit a new burner, igniter or valve and the grill goes back to work.
We also design, fabricate and repair outdoor kitchens, including the islands, cabinets and built-in appliances in them. If part of yours has worn out or no longer works the way you want, we can look at it.
Smokers, griddles, pizza ovens, fireplaces and fire pits get the same service.

Inspections & maintenance
Inspections and regular maintenance
An inspection is a full check of the gas connections, burners and ignition, finished with a written report. It lists what is in good shape, what is wearing and what needs attention soon. It is useful before a big cookout, after a grill has sat unused, or when you are deciding whether to repair or replace.
Most homes do well with a cleaning every 6 to 12 months. If you grill several times a week, go closer to six.
The Protection Plan membership puts those cleanings on a schedule, so you do not have to remember to book them.
Wear and tear
What wears grills out in Bel Air
Bel Air sits inland, away from the salt air that rusts burners and igniter tips near the beach. Here the usual troubles are heat, dust and spiders. Long, hot grilling seasons bake grease onto grates, heat plates and the firebox, and it hardens the longer it stays.
Dust settles into burner ports, and spiders move into the venturi tubes, especially on grills that sit covered between parties. Either one can leave you with weak flames, hot spots or a burner that will not stay lit. A cleaning before the season starts catches most of it.
When it's time to replace
New grills, measured and installed
Sometimes repair stops making sense, such as a firebox rusted through or parts that cost more than the grill is worth. In that case we measure the cutout, help you pick a grill that fits, sell it, install it and haul the old one away.

What to expect
What a visit looks like
- You book and tell us what the grill is doing, with a photo of the model and serial label if you can.
- The technician arrives, looks the grill over and explains what it needs.
- Cleaning, repair or both are done on site.
- We test the grill before we leave.
- We clean up our work area, and you get a written report if the visit was an inspection.
Pro Grill has serviced over 25,000 grills since 2018 and has 2,500+ five-star reviews (Google, Yelp and Facebook). Our team has 50+ years of combined grill experience, and we are insured.

