Mobile service
We come to you in Studio City
Pro Grill is a mobile service. A technician drives to your house, sets up next to the grill, and does the work there. Nothing gets loaded into a trunk, and nobody has to haul a greasy firebox across the Valley.
That matters most for built-ins. A grill set into a masonry island or a stainless frame is not going to a shop, so we work on it in place, with drop cloths down and the island protected.
We book visits across Studio City, including Colfax Meadows, Wrightwood Estates, Sunshine Terrace, Tujunga Village, and the hillside streets around Fryman Canyon, Laurel Canyon and Coldwater Canyon. If your driveway is steep, your gate has a code, or the patio is tight to reach, tell us when you book so the truck is ready for it.
We started in Southern California in 2018, now work in Arizona too, and have serviced over 25,000 grills. The team has 50+ years of combined grill experience, and we are insured. We have 2,500+ five-star reviews (Google, Yelp and Facebook).
Deep cleaning
Deep grill cleaning
A deep cleaning is a full teardown, not a wipe-down. Here is what we go through:
- Cooking grates, scrubbed and checked for rust, flaking and loose welds
- Burners, cleaned inside and out, with the ports cleared
- Heat plates or flavorizer bars, scraped and inspected for burn-through
- Briquette trays and briquettes
- Firebox, scraped down to bare metal where grease has baked on
- Drip tray and grease management system, emptied and cleaned
- Igniter electrodes, cleaned and tested
- Hood and outside stainless, cleaned and polished
- Our work area, cleaned up before we leave
Buildup is more than a looks problem. Grease and carbon feed flare-ups, and they block burner ports so the heat comes out uneven. Wet residue holds moisture against steel, which starts rust. Burners that sit in that mess rot out from the outside in, and replacing them costs far more than cleaning them on time.

Start with the symptom
BBQ repair at your Studio City home
Most grill problems come from a short list of worn or clogged parts. These are the ones we see most, and what we usually do about them.
Uneven heat and hot spots
Usually clogged burner ports, a warped heat plate, or grease buildup. We clean or replace the burner and heat shield, then check the flame across the whole grill.
Spiders and nests in the venturi tubes
Insects build in the tubes that feed gas to the burner, which blocks the flow. The flame turns weak or yellow, or burns at the back of the tube. We clear the tubes and check the burner for damage.
Low flame, regulator stuck in bypass
A regulator that trips into low-flow mode will hold the grill at a weak flame no matter where the knobs are set. We reset it if that works and replace it if it doesn't.
Flare-ups and grease fires
Flames jumping above the grates mean grease where it shouldn't be, or heat plates that no longer shed drippings. We clean out the grease, replace what is burned through, and clear the drip path.
Igniter clicks but won't light
The cause is usually a dead battery, a dirty or corroded electrode, or a loose wire. We test the spark and replace the part that failed.
Smells like gas
Shut the gas off at the tank or the line and do not light the grill until it has been checked. We test hoses, fittings, valves and regulator connections for leaks and fix the source.
Knob spins but nothing happens
The knob has come loose from the valve stem, or the stem is stripped or broken. We replace the knob or the valve, depending on what we find.
Burned-through trays and heat shields
Years of grease and high heat eat through briquette trays and shields. Once they fail, the burners are exposed and the heat goes uneven. We fit new ones sized to your grill.
Repair it right
Diagnose first, then buy parts
The same symptom can come from different problems. A weak flame might be a bad regulator, a clogged tube or a dirty burner. Guessing means paying for a part you didn't need, so we check first and replace only what has failed.
If you can, send a photo of the model and serial number label before the visit. It is usually on the frame, inside a cabinet door, or on the back of the grill. With it, we can bring the right parts on the truck.
The truck carries parts for most brands. If something needs ordering, store.progrill.com stocks parts for most built-in grills.
Built-ins & outdoor kitchens
Built-in grills and outdoor kitchens
When one part fails on a built-in, repairing it is usually the better move. The grill is sealed into the island, and swapping it means cutting or reworking the cutout. A new burner, valve or igniter costs a fraction of that.
We also design, fabricate and repair outdoor kitchens. That covers islands, counters, access doors and the appliances built into them.
The same visit can cover other backyard cooking and heating gear. We service smokers, griddles, pizza ovens, fireplaces and fire pits.

Inspections & maintenance
Inspections and maintenance for Studio City grills
An inspection is a full check of the gas supply, burners and ignition, finished with a written report. It tells you what is working, what is wearing out and what to expect next. It's useful before a big cookout, after a grill has sat unused, or when you are buying a house with a built-in.
Most homes should have the grill cleaned every 6 to 12 months. If you grill several times a week, or cook a lot of fatty meat, lean toward the shorter end.
The Protection Plan membership sets up scheduled cleanings so you don't have to remember. Ask us about it when you book.
Wear and tear
What wears grills out in the Valley
Studio City is inland, so salt air isn't the issue. Long stretches of summer heat bake grease onto firebox walls and burn through thin heat shields and briquette trays. Heat also wears on knobs, hoses and igniter wiring.
Dust gets into burner ports and venturi tubes, and spiders like the tubes. A grill that has sat under a cover for a few weeks can have a blocked tube by the time you fire it up. Lighting it, then looking at the flame, is the quickest check. A lazy yellow flame or a burner that lights only at the back is a reason to call.
Start with the symptom
New grills when repair doesn't make sense
Sometimes a grill is past fixing: the firebox is rusted through, the frame is warped, or the repair would cost more than the grill is worth. We will tell you that plainly.
If you replace it, we measure the cutout, sell you a grill that fits, install it, and haul the old one away.

What to expect
What a visit looks like
- Book online and tell us the grill type, the problem, and your gate or parking details.
- A technician arrives in the window we give you and checks the grill first.
- We explain what we found, and what needs cleaning or replacing, before we start.
- We clean, repair or both on the same visit when the parts are on the truck.
- We test the grill, clean our work area and go over what we did.

