Mobile service
We come to your North Palm Beach home
Pro Grill is a mobile service. A technician drives to your house with the tools and most of the parts, and the work happens at the grill. Nothing gets loaded into a truck and nothing sits in a shop for a week.
That matters most for built-ins. A grill set into a stone or stucco island is not going anywhere, and it doesn't need to. We work in place, whether the grill is on a patio in Old Port Cove, beside a pool in Lost Tree Village or on a back lanai in Lakeside Green.
We cover all of North Palm Beach, including Old Port Cove, Lost Tree Village, Lakeside Green, Twin Lakes, the Country Club of North Palm Beach area and Anchorage. If your street isn't named here, mention it when you book.
Deep cleaning
Deep grill cleaning
A deep clean is more than a scrape and a wipe. We take the grill apart, clean each piece and put it back together working properly. Here is what's included:
- Cooking grates, scrubbed and rinsed
- Burners, with every port cleared of grease and debris
- Heat plates or flavorizer bars
- Briquette trays
- Firebox, scraped out and degreased
- Drip tray and grease management system
- Igniter electrodes, cleaned so they spark where they should
- Hood interior and the outside stainless
- Cleanup of our work area when we're done
Buildup is not just a looks problem. Old grease feeds flare-ups and can catch fire in the firebox. Caked-on residue blocks burner ports, so the heat comes out uneven and one side of the grill runs cold. Moisture trapped under grease and ash speeds up rust, and burners that sit in that mess rot out sooner than they should.

Start with the symptom
BBQ repair in North Palm Beach
We repair burners, valves, igniters, grates, briquettes, heat plates, knobs and regulators. These are the problems we see most often on grills this close to salt water.
Knobs and valve stems that seize
Salt and moisture lock the stem inside the valve. We free it, clean and lubricate it, or replace the valve if the stem is too far gone.
Igniter clicks but nothing lights
The electrode tip is usually corroded or coated in grease, so the spark never reaches the burner. We clean or replace the electrode and check the wiring and module.
Hood hinges and handles corroding
Humid air eats the fasteners and hardware first. We replace worn hinges, handles and bolts so the lid opens and closes the way it should.
Grates rusting or flaking
Bare cast iron and thin plated steel both break down in damp air. If cleaning and re-seasoning won't save them, we fit new grates sized for your model.
Burners rusted through
Salt air and grease drippings eat burner tubes from the outside in. You'll see holes, ragged flames or flame only at one end. A new burner fixes it.
Won't get past 300 degrees
Common causes are a regulator stuck in low-flow mode, clogged burner ports or a kinked hose. We test the pressure, find the restriction and correct it.
Smells like gas
Shut the gas off at the tank and do not light the grill until it has been checked. We pressure-test the hoses, fittings and valves to find the leak and fix it.
Repair it right
Diagnosis comes before parts
The same symptom can come from different problems. A grill that won't light might need a new igniter, or it might need a clean burner and a fresh battery. We check first, then replace only what failed.
Before your visit, take a photo of the label with the model and serial number. It's usually on the frame, inside a cabinet door or on the back of the cart. With that, we can match parts before we arrive. Our truck carries parts for most brands, and more are available at store.progrill.com.
Built-ins & outdoor kitchens
Built-in grills and outdoor kitchens
When one part fails on a built-in, repairing it almost always makes more sense than tearing out the island. Burners, igniters, valves and heat plates can be replaced in place, and the grill goes back to work.
We also design, fabricate and repair outdoor kitchens: islands, cutouts, doors, drawers and the grill that goes in them. Beyond gas grills, we service smokers, griddles, pizza ovens, fireplaces and fire pits.

Inspections & maintenance
Inspections and regular maintenance
An inspection is a full check of the gas supply, burners and ignition, finished with a written report. It's useful before the season starts, when you buy a house with a grill, or any time something seems off but you can't say what.
Most homes should have a deep clean every 6 to 12 months. If you grill several times a week, plan on the shorter end.
The Protection Plan is a membership that puts scheduled cleanings on the calendar, so you don't have to remember to book. Ask about it when you schedule a visit. We have 2,500+ five-star reviews (Google, Yelp and Facebook).
Wear and tear
What salt air does to a North Palm Beach grill
North Palm Beach sits on the Intracoastal, close to the ocean, so a grill here lives in salty, humid air all year. That air rusts burners and grates, pits and stains stainless steel, and corrodes igniter tips and hinge hardware.
A grill with a cover and a regular cleaning schedule holds up much better. Wiping down the stainless and keeping the firebox free of grease and wet ash slows the damage, but it doesn't stop it. That's why parts here wear out sooner than the same grill would elsewhere.
When it's time to replace
New grills: measured, installed, old one hauled away
Sometimes repair stops making sense, for example when the firebox has rusted through or the cost of parts is close to a new grill. In that case we measure your cutout, sell you a grill that fits, install it and haul the old one away.

What to expect
What a visit looks like in North Palm Beach
- You book online and tell us what the grill is doing.
- The technician arrives in the window we gave you.
- We look the grill over and tell you what we find.
- We clean, repair or both, with your approval of any parts.
- We test the grill, clean up our work area and go over what we did.

